SDK Questions
Posted: Sun May 29, 2016 7:17 pm
Hi there,
I am looking for a little advice on SDK issues I am experiencing
- When using the Compressor/Compressor Stereo modules, I note the VU does not seem to work. It is connected to the SC0 pad, but driving it hard shows no indications?
- On occasions I get 1000 Stack errors when using certain controls (eg sometimes using the Ratio control on a compressor, or dragging a Freq node on the EQ module). Is there something that can be done to arrest these errors?
- If I set a module to a particular DSP, will that then limit its use to only XITE?
Thanks
maus
I am looking for a little advice on SDK issues I am experiencing
- When using the Compressor/Compressor Stereo modules, I note the VU does not seem to work. It is connected to the SC0 pad, but driving it hard shows no indications?
- On occasions I get 1000 Stack errors when using certain controls (eg sometimes using the Ratio control on a compressor, or dragging a Freq node on the EQ module). Is there something that can be done to arrest these errors?
- If I set a module to a particular DSP, will that then limit its use to only XITE?
Thanks
maus