Maybe I'm just paranoid and a bit manic
I'm wiring up a circuit with groups of modules folded together (mixers, filters etc.). I'm trying to get things ready to set the whole thing up for presets.
So I'm having three circuit level pots connected to a mix3 module, and to controller pads that are exported. The pot are set up with CtrlNr under vars in the pad list.
However, when I save, close and reopen the project, the mix3 modules c1, c2 and c3 are connected "Midi Contr Filter I/O..." via antennas, instead of to the circuit level pots.
Why are the routing taking this detour by itself? Is there a (more) right way to hook things up?
Regards
Søren
Connections and midi control
Re: Connections and midi control
to save midi control settings, you need to make a midi preset for the device.
-
- Posts: 92
- Joined: Sat Feb 06, 2010 12:52 pm
Re: Connections and midi control
garyb wrote:to save midi control settings, you need to make a midi preset for the device.
Thanks for your answer (wow, that was fast ). I probably was't too clear in my question. It's not the preset I'm asking about, but the routing.
The SDK changes the control routing, so everything goes thru the "Midi Contr Filter I/O..." module, instead of straight to the "target" module. Is this intentionally or just some other weired quirk?
....am I making sense?
Regards
Søren
Re: Connections and midi control
ahh, ok i was no help.
i'm not the right guy to answer. sorry...
i'm not the right guy to answer. sorry...