SETUP: PULSAR II + DSP expansion - Scope v. 7.0 1706, CAKEWALK last version (previously SONAR), MOTU 828mkII.
Windows 10 64b upgraded.
I always used WAVE Dest/Source, now I wish to use ASIO.
Listing the ASIO Dest available I have only "ASIO Dest" (16b) "ASIO Float Dest" "ASIO2 Dest" "ASIO2 Float Dest",
it seems there are no 24 bit versions.
MOTU ASIO is 24 bit so I need to choose probably the same type for all.
Pls. help!
Bob
ASIO 24 bit not listed
Re: ASIO 24 bit not listed
use the ASIO or ASIO2 source and the matching destination.
if your DAW is 24bit, the ASIO driver will also be 24bit.
if your DAW is 24bit, the ASIO driver will also be 24bit.
Re: ASIO 24 bit not listed
You're right ! Setting DAW to 24 bits they appear as 24 bits.
But my DAW doesn't allow to use MOTU ASIO and SC ASIO at the same time... is it normal ?
But my DAW doesn't allow to use MOTU ASIO and SC ASIO at the same time... is it normal ?
Re: ASIO 24 bit not listed
yep, that is how ASIO works.
Re: ASIO 24 bit not listed
Correct.
Re: ASIO 24 bit not listed
Thank you for helping me.
I have found old projects of mine having "ASIO 24" and still working, that's why I was confused.
So, knowing that only 1 ASIO device can be used at once in the DAW, this is what I've done, succesfully:
- connected my SCOPE to MOTU 828mkII with two ADAT IN and OUT optical cables
- set my MOTU as "Master" clock
- set my SCOPE as "Slave" selecting ADAT as source sync
- in addition to the correct sync (without clicks & glitches), obviously, when I change clock in MOTU (44.1 48 96) it automatically changes in SCOPE
- in my DAW I choosed MOTU drivers and I see all INs/OUTs including ADAT ones (clock must be set accordingly to MOTU)
- I still can use SCOPE HW analogue OUTs connecting them to MOTU INs
I have found old projects of mine having "ASIO 24" and still working, that's why I was confused.
So, knowing that only 1 ASIO device can be used at once in the DAW, this is what I've done, succesfully:
- connected my SCOPE to MOTU 828mkII with two ADAT IN and OUT optical cables
- set my MOTU as "Master" clock
- set my SCOPE as "Slave" selecting ADAT as source sync
- in addition to the correct sync (without clicks & glitches), obviously, when I change clock in MOTU (44.1 48 96) it automatically changes in SCOPE
- in my DAW I choosed MOTU drivers and I see all INs/OUTs including ADAT ones (clock must be set accordingly to MOTU)
- I still can use SCOPE HW analogue OUTs connecting them to MOTU INs
Last edited by bob4u on Sun Aug 04, 2019 10:08 am, edited 1 time in total.
Re: ASIO 24 bit not listed
good.
the MOTU is kinda "the department of the redundancy department", but whatever works for you...
the MOTU is kinda "the department of the redundancy department", but whatever works for you...