PlanetZ forums - scopeusers.com

As far as i can see it's clearly defined in the dropdowns which ins/outs belong to what card. I have another question. I see that I have gotten a key for modular 2 with my new card. But it's not installed with the software since originally i didn't have the key. Do i have to reinstall the drivers/so...

i wish i could tell you. I'm still waiting for my S/TDM cable :-/

Thank you very much, Tom. You are my hero for today

Now, I hope I can fit the 2nd board on my motherboard!

Have a nice day!

//Summer

Ok thanks for the info !!

Still, I'm wondering how the pulsar 1 can suddenly get lower latency. I've never been able to get less than 10 ms with that card. Is it because only the DSPs are used from that system?

So is it like the one with the lowest IRQ becomes the master?

I'm thinking of buying an extra Pulsar2/Scope Project card (6 DSPs) for my almost 8 years old pulsar 1 card with 4 DSPs. Should that give any problems? The DSPs are the same I would think so i guess they should still work together? As far as I know the only thing that's a bit annoying is that the pu...

wohoo this thread made my day!

How can you only have two cards? Scope, Powercore and Firewire? (Well, don't know the Powercore).

But as AdreD sugest... try moving around your cards.

hm...before you do that you should check your power supply.


I've had strange things happening in a building that had powerfluctuations. After trying another poweroutlet I had no problems.

- Summer

hehe.. yeah well... I use my pulsar 1 (yes "one") only as a low latency card for cubase. Most synths are vsti and I still can't get XTC to work...

I have two monitors _not_ running at the same resolution. How do I get Cubase SX on both monitors _and_ with a maximized window?

I can't stretch the window from one to another coz the resolution isn't identical.

Ideas are appreciated and kissed =)

- Summer

Thank you very much! that did the job... ahh... i've missed that completely

regards
summer

Is it possible to make cubase busses behave like busses in logic? I liked the way I could route tracks through a virtual bus and then out through the master bus. The problem is: I want to add the same compressor to the bassdrum and the bass. I can only get the desired effect by sending them through ...

I have the excact same problem and havn't been able to find a solution.

Regs
Summer

I don't get it... I had the dropout problem on my p2-400mhz 128mb ramm And now I STILL have it even though I running p4-1.7ghz 512mb ram. all I have to do to get dropouts is to play some midi in logic. no waves beeing played from the HD nor did I have any plugins activated.??? and that's with the lo...