Which slots to use on an Asus Tusl-c?

helldriver · Post by **helldriver** » Sun Feb 24, 2002 2:18 pm

I have bought an Asus Tusl-c and want to use it with a pulsar1 and a pulsar2. Which PCI slots and which IRQ are the best for this setup?
Thanks in advance for anyones help

Stefan

<font size=-1>[ This Message was edited by: helldriver on 2002-02-24 14:20 ]</font>

Round1 · Post by **Round1** » Sun Feb 24, 2002 9:49 pm

Hi,
I've got a CUSL2-C, which is basically the same MB, except yours accepts Tulatin cpu's. At the moment I've got a Luna II in slot three, and in the BIOS I've set it to IRQ 5/not shared. This works fine for me in Win98SE & WinXP.
In the past I've had a Korg 1212I/O in slot 3 with the same BIOS setting, and also a SBlaster Live! in slot 2 with the IRQ left to AUTO in the BIOS. This also worked fine.
AFAIK slots 1 & 5 are shared, and from my research not recommended for audio cards.
Hope this helps.

Neutron · Post by **Neutron** » Sun Feb 24, 2002 10:04 pm

I would put your cards in slots 1 and 5 they are shared on that board, and creamware cards like to share the IRQ.

go into the BIOS and force the slots to an IRQ (i use IRQ 5, it is quite low priority though you could use 10 or 11 if they are free, and they have higher priority)

IRQ priority is 0 1 (2) 8 9 10 11 12 13 14 15 3 4 5 6 7

there used to be only 8 irqs in the old days of 8086s and the "Standard" became to kludge together 2 IRQ chips in a daisy chain fashion.
the IRQs on the second chip are redirected to irq2, thet is why the order is stramge looking.

brought to you by the bureau of useless information

<font size=-1>[ This Message was edited by: defex on 2002-02-24 22:06 ]</font>

helldriver · Post by **helldriver** » Mon Feb 25, 2002 4:20 am

Thanks round1 and defex for your answers.
It will help me.

Stefan

Vil · Post by **Vil** » Mon Feb 25, 2002 4:54 am

i use slots 1 and 5 and IRQ 9 for my Luna + Scope I . Works just great .

at0m · Post by **at0m** » Mon Feb 25, 2002 7:23 am

Slots1 & 5? How about STDM cable?

Vil · Post by **Vil** » Mon Feb 25, 2002 9:48 am

sure , STDM is connected too .

helldriver · Post by **helldriver** » Wed Feb 27, 2002 6:37 pm

I put my two cards into slot1 and 5. But then I have to see that the card which is in slot one is rather close to the cooler of Matrox G400 DH. Could such a close setup harm
my pulsar in slot1?
Can I use my two cards in slot 3 and slot 5 (both with interrupt 10) as good as in slot 1 and 5?
greets
Stefan