STS Sample does not load any sample - low memory error

[cascade]

Got my new XITE-1. When trying to load any sample or library into any instance of the STS (3000, 4000 or 5000) it says

low memory error

Even when i try to create a new one ??????!!!!!

Running Windows XP SP3 @ ASUS P7P55D-E, 4 G RAM, 150 G WD Raptor, Intel Core i5 @ 2.6

In my old PC (also Win XP SP3 but other board and CPU) using the LUNA + Pulsar SRB (9 DSP) configuration, the STS 5000 worked perfectly.

Is there any trick? All forum posts regarding that problem didn't help.

There is definetely enough memory free. damn

THX

[siriusbliss]

You may have to assign the STS to a lower-numbered DSP, such as #6 (or something).

I doubt the STS's are optimized for the Xite DSP cascade.

Greg

[cortone]

cascade,

I've seen this as well. I can usually restore it by closing out scope (and my DAW first if it's already started), and re-starting scope. I have to do this most of the time, but once it's up, it's solid. Sometimes I need to shut down the entire system and power-cycle the XITE, but that is very rare.

I have experimented with assigning the STS to one of the first six DSPs, but haven't seen much benefit from it, but it's worth a try on your system to see if it helps.

Cheers,
Cory

[cascade]

Hi @all

None of the suggestion helped. When trying to assign DSP 1 - 6 (one of them) to the STS, i get a error message asking if i want to optimize whatever (do not have exact notation available). When i use DSP 7 - 18 it works (from the assignment point of view) but still get lowmemory error. Even restarting machine or XITE does not help.

Damn :-/

[David]

are you using the latest release of Scope?

ftp://sonic-core.net/software/scope5/SO ... 617_EN.exe

[cascade]

Sure !!

Installation was on 26th of December using actual Version of Scope.

Find a screenshot of the STS 5000 message when trying to create a new sample.

[mausmuso]

HI There,
I am getting the same thing on my XITE with all of the STS samplers.
reassigning DSP does not seem to help
I have 3.5 GB of RAM (I assume its RAM its reporting on) and in STS 5000 it reports 2Gb available with 0 used.
When I first tried the samplers they worked fine, but as soon as I went to use them in a project - LOW MEMORY and they have'nt worked since.
I might try the reboot trick mentioned here and see what that does.
any other thoughts?
maus

[mausmuso]

I just tried closing SCOPE and then restarting and it works.
It looks like there must be some residual memory allocations that don't get cleared or something
maus

[tjsound]

try to remove scope from auto- startup and load scope manually after reboot windows, be shure that scope is running "as administrator"