Konnekt 24d+Cubase4: Scope XTC-problems
Posted: Wed Jan 31, 2007 12:29 am
I know this type of issue is disucussed here before, but I'm quite desperate and hope someone can help me for this particular setup:
I have a new TC Konnekt 24d, which is great, and use Cubase 4.
I want to use my 2 scope cards (pulsar 1 and SRB; total of 8 dsp) in XTC mode in cubase.
But I get the message 'Pulsar cannot be used in accelerator mode' when I try to load a device. The device loads and is visible, but it just doesn't work. XTC-mode is proper installed, I tried all options in the scope I/O settings, nothing works so far.......
Someone?
I have a new TC Konnekt 24d, which is great, and use Cubase 4.
I want to use my 2 scope cards (pulsar 1 and SRB; total of 8 dsp) in XTC mode in cubase.
But I get the message 'Pulsar cannot be used in accelerator mode' when I try to load a device. The device loads and is visible, but it just doesn't work. XTC-mode is proper installed, I tried all options in the scope I/O settings, nothing works so far.......
Someone?