Having an issue regarding a new install on win 10.
I managed to run the installer with no issues after enabling test mode. The drivers show up fine, the Luna was recognized as "Scope PCI X" or something similar.
However, when i try to launch the Scope app as admin, i get the following error
pressing OK brings up the following:
If i try to run it again afterwards, it says:
I haven't been asked for serials/allkeys yet. I have tried to reinstall, no luck.
Anyone have any experience with this?
Board (0) is not a luna card - new install
Re: Board (0) is not a luna card - new install
Never mind, re-seating the card and some minor cleaning solved it. Ill let the post stay for reference
Re: Board (0) is not a luna card - new install
LOL. The cards need a little TLC once in a while.
"I’ve come to the conclusion that synths are like potatoes, they’re no good raw—you’ve got to cook ‘em, and I cooked these sounds for months before I got them to the point where they sounded musical to me." Lyle Mays