Modular IV installation issue

Anything about the Scope modular synths

Moderators: valis, garyb

Post Reply
User avatar
tlaskows
Posts: 1512
Joined: Fri May 20, 2005 4:00 pm
Location: Ontario, Canada
Contact:

Modular IV installation issue

Post by tlaskows »

Hi,

I believe that I installed Modular IV correctly. It loads up fine, but whenever I load up a project/preset, the patch cables are missing! Did I forget a step?

Thanks,

-Tom
User avatar
dante
Posts: 5043
Joined: Sat Nov 24, 2001 4:00 pm
Location: Melbourne Australia
Contact:

Re: Modular IV installation issue

Post by dante »

Did you click on the little square coloured buttons at top for cabling ?

http://www.hitfoundry.com/issue_10/sorcerer.htm
User avatar
tlaskows
Posts: 1512
Joined: Fri May 20, 2005 4:00 pm
Location: Ontario, Canada
Contact:

Re: Modular IV installation issue

Post by tlaskows »

Hmm, yes, I just checked. The patch cables are set to visible. I can make a patch and it shows up. It's not patched when I load it...

Weird.

-Tom
User avatar
tlaskows
Posts: 1512
Joined: Fri May 20, 2005 4:00 pm
Location: Ontario, Canada
Contact:

Re: Modular IV installation issue

Post by tlaskows »

I'm getting sound out of your Pad Machine, but no cables are visible :(

Nice sound, good job.

-Tom
User avatar
dante
Posts: 5043
Joined: Sat Nov 24, 2001 4:00 pm
Location: Melbourne Australia
Contact:

Re: Modular IV installation issue

Post by dante »

Even the little grey left hand 'routing' square ?
modular
modular
modcolor.JPG (1.87 KiB) Viewed 4248 times
User avatar
tlaskows
Posts: 1512
Joined: Fri May 20, 2005 4:00 pm
Location: Ontario, Canada
Contact:

Re: Modular IV installation issue

Post by tlaskows »

That did the trick!

Awesome, thanks a lot.

-Tom
Post Reply