actually i see sc-plate (ex- stw p100) as one of the reasons to own a pulsar
it's so damn good... midi for it is a must! i don't remember if p100 had midi control but it's essential... without midi it's just static, standing still. and all fun is gently twisting parameters...and now it's only via mouse, one at a time...
SC-Plate: how comes no midi control>?
Re: SC-Plate: how comes no midi control>?
use it as insert effect inside a module with midi inputs, such as the multi fx module and you'll be able to assign midi cc's to the reverb.
Re: SC-Plate: how comes no midi control>?
thanks and thanks!!
Re: SC-Plate: how comes no midi control>?
Sorry if I'm in wrong thread but I searched and wound up here! When I load SC Plate it loads into the project but next time it starts I get like board communications errors and reset sample rate dialogs until SCOPE goes south. I renamed the dev file so SCOPE wouldn't find it and would load the project so I could delete the device from the pane. Running 5.1 on Win 7 64. This is not a show stopper but I heard a lot of good things about SC Plate and would like to give it a whirl.
Re: SC-Plate: how comes no midi control>?
The Plate use a lot of DSP modules - so Scope can't place all the modules on the same DSP. It would be best to load the Plate before any other devices (especially RAM based devices).
Re: SC-Plate: how comes no midi control>?
I really like using the BC2x2RP Shell with Plate X.
I can add some EQ or a Filter, plus MIDI, and the Shell is recallable so it pops up from a screenset, and the Plate X and other stock plugs, in it's serial alignment, are all on the screen simultaneously.
Real Nice...
I can add some EQ or a Filter, plus MIDI, and the Shell is recallable so it pops up from a screenset, and the Plate X and other stock plugs, in it's serial alignment, are all on the screen simultaneously.
Real Nice...