For optimizing Xite power, I learned to load insert fx chains outside of the mixer. So I put a lot of multi fx modules in the project window.
Untill now, I didn't use much the live bar. Probably, a lot of people already know this but recently, I discovered that one can change device names in the live bar like here :
Now, I know to which channel any (sometimes more than 15) multi fx device belongs. And I lose fewer time to look for !
Name in the live bar.
Re: Name in the live bar.
Merde !
I realized that after reloading the project, all the names are back to "multifx" !
What th..f..k !?!?
I realized that after reloading the project, all the names are back to "multifx" !
What th..f..k !?!?
Re: Name in the live bar.
Yepp.
You can change names and sizes of the Mixers in the project window, but that Live Bar stuff slapped me a wqhile back too.
Spent a lot of time giving names for everything, making it all neat and then finding out it was wasted time.
Valuable lesson though.
You can change names and sizes of the Mixers in the project window, but that Live Bar stuff slapped me a wqhile back too.
Spent a lot of time giving names for everything, making it all neat and then finding out it was wasted time.
Valuable lesson though.
Re: Name in the live bar.
It's a pity ! I found that so useful that I had made this thread !
The preset name appears too (and without disapearing !) but it's a pain just for naming.
The preset name appears too (and without disapearing !) but it's a pain just for naming.