Simultaneous use of external spdif and ADAT converters
-
- Posts: 88
- Joined: Sat Feb 11, 2006 4:00 pm
Simultaneous use of external spdif and ADAT converters
I am using an 2-channel AD and an 8 channel ad/da with Luna2 + Pulsar setup. The 2-channel AD can only send clock over SPDIF but not receive. Is there a way to 'forward' clock signal to the ADAT converter when clocking off the 2-channel A/D? Thanks
Re: Simultaneous use of external spdif and ADAT converters
sure, if the ADAT device has inputs too. you'll need to connect inputs(output fro the Scope card) and have the device slave to ADAT.
-
- Posts: 88
- Joined: Sat Feb 11, 2006 4:00 pm
Re: Simultaneous use of external spdif and ADAT converters
Thanks. This will simplify my setup.garyb wrote:sure, if the ADAT device has inputs too. you'll need to connect inputs(output fro the Scope card) and have the device slave to ADAT.