Send audio Ramp to Flexor from Renoise

Anything about the Scope modular synths

Moderators: valis, garyb

Post Reply
User avatar
ChristianB
Posts: 68
Joined: Thu Feb 10, 2005 4:00 pm
Location: Montréal

Send audio Ramp to Flexor from Renoise

Post by ChristianB »

Hi

Sending audio Ramp to Flexor
I manage that from Cubase : one cycle ramp on each bar and it work!
So I did bounce that ramp to a file : 120bpm_1Bar
load it in Renoise in the sample player = not working
Then in a sampler : Bliss, Independence, Falcon = not working

Any body any ideas ?

Thanks
User avatar
roy thinnes
Posts: 651
Joined: Thu Jan 09, 2003 4:00 pm
Location: Graz
Contact:

Re: Send audio Ramp to Flexor from Renoise

Post by roy thinnes »

controlling Modular sequencers externally (by sending a Ramp signal from your DAW) works quite perfect.
Give the Ramp signal a specified Asio output, connect it to Modular, and you're good to go (but be careful not to connect it to the audio mixer, otherwise you'll ruin your headphones/speakers).

Depending on your DAW, you'll probably have to check what time stretch method is most appropriate to have a tight rhythm.

If nothing is happening on the Modular side you have a connection problem (check the Modular input signal with a ValMeter module).
User avatar
ChristianB
Posts: 68
Joined: Thu Feb 10, 2005 4:00 pm
Location: Montréal

Re: Send audio Ramp to Flexor from Renoise

Post by ChristianB »

HI Roy

It is perfect I agree !!!
But
Renoise is refusing to send it properly.... Cubase fine, Samplitude fine, etc
I'm starting a project and Renoise is the best for doing the job... but no Ramp
:-(
jksuperstar
Posts: 1638
Joined: Mon Nov 15, 2010 12:57 pm

Re: Send audio Ramp to Flexor from Renoise

Post by jksuperstar »

Do you see the waveform properly? Maybe in saving the ramp as wave, something is bad.

You can generate a sawtooth wave, use a simple LFO, or synth to send the audio ramp, just tune it to 2Hz for 120bpm and capture the wave again.
User avatar
ChristianB
Posts: 68
Joined: Thu Feb 10, 2005 4:00 pm
Location: Montréal

Re: Send audio Ramp to Flexor from Renoise

Post by ChristianB »

I just got back to that project yesterday
And... After spending couple of hours trying this and that,
I found that in Renoise on the Master track, the DC filter check box was tick !!!!!
I felt stupid
but then I was surprise that the DC offset is apply to all outputs not just the master.
Happy Renoise user now!!! I got an audio Ramp to MODular IV, from 30 to 999 bpm without having to change anything !
Cheers
Post Reply