Page 1 of 1
Modular IV installation issue
Posted: Fri Mar 13, 2015 1:30 pm
by tlaskows
Hi,
I believe that I installed Modular IV correctly. It loads up fine, but whenever I load up a project/preset, the patch cables are missing! Did I forget a step?
Thanks,
-Tom
Re: Modular IV installation issue
Posted: Fri Mar 13, 2015 1:48 pm
by dante
Did you click on the little square coloured buttons at top for cabling ?
http://www.hitfoundry.com/issue_10/sorcerer.htm
Re: Modular IV installation issue
Posted: Fri Mar 13, 2015 2:28 pm
by tlaskows
Hmm, yes, I just checked. The patch cables are set to visible. I can make a patch and it shows up. It's not patched when I load it...
Weird.
-Tom
Re: Modular IV installation issue
Posted: Fri Mar 13, 2015 2:40 pm
by tlaskows
I'm getting sound out of your Pad Machine, but no cables are visible
Nice sound, good job.
-Tom
Re: Modular IV installation issue
Posted: Fri Mar 13, 2015 8:34 pm
by dante
Even the little grey left hand 'routing' square ?
- modular
- modcolor.JPG (1.87 KiB) Viewed 4291 times
Re: Modular IV installation issue
Posted: Sat Mar 14, 2015 2:47 pm
by tlaskows
That did the trick!
Awesome, thanks a lot.
-Tom