Flexor envelopes
Posted: Sat Dec 13, 2014 2:36 pm
Since 1 hour and half, I'm pulling my hairs out ! HELP !
I was trying different envelopes SC, BCmodular, Cwmodular and then Flexor. When I start with Flexor envelopes, impossible to get an envelope signal ! One's the env output is always at 1, one's the output is allways at 0 !
I even tried with the Flexor "Gate" module.
As I connect Flexor envelopes exactly in the same way as the other, It can't be a wiring issue. I read all the Flexor manual. I took care to connect Esync MVC to gate MVC -> nada.
I made just this little patch : it's a simple midi gate : the sound goes from input to output when a midi note is received. This works perfectly with any other envelope module exept Flexor ones.
If anyone has some time to spend and try it... I'd like to know if the issue comes from my Scope install or from Flexor envelope module.
Ah yes ! I tried a lot of Flexor patches to check and each time, it was SC envelope modules which were used !
Many thanks.
I was trying different envelopes SC, BCmodular, Cwmodular and then Flexor. When I start with Flexor envelopes, impossible to get an envelope signal ! One's the env output is always at 1, one's the output is allways at 0 !
I even tried with the Flexor "Gate" module.
As I connect Flexor envelopes exactly in the same way as the other, It can't be a wiring issue. I read all the Flexor manual. I took care to connect Esync MVC to gate MVC -> nada.
I made just this little patch : it's a simple midi gate : the sound goes from input to output when a midi note is received. This works perfectly with any other envelope module exept Flexor ones.
If anyone has some time to spend and try it... I'd like to know if the issue comes from my Scope install or from Flexor envelope module.
Ah yes ! I tried a lot of Flexor patches to check and each time, it was SC envelope modules which were used !
Many thanks.