Example modular 2 & 3 (but not Flexor) patchords are missing and can't be made to show, although when you make a new one it shows. Don't know if this happens in all setups or just some. The problem showed up in my system in XP and Win7, in Scope PCI and Xite. Only the example patches, not the patches I had created or example patches I had modified. I only recently noticed this because I hadn't looked at the example patches since I don't remember when.
It turns out there is an easy fix. You only need to copy the example patches from an old version of Scope. I used v4.5, I would guess v4.0 would work as well. Problem fixed. I'm almost certain there are no new patches in Scope v5, so this fix should work without any down side. Seems to work OK on my setup, for both PCI and Xite.
Missing Patchcords in Scope5 Modular Examples
Re: Missing Patchcords in Scope5 Modular Examples
Got a response from Holger at S/C, who said the problem is known, and has been fixed for the next update.
Re: Missing Patchcords in Scope5 Modular Examples
did he say when "the next update" is gonna happen?
--
I'm sorry, but my karma just ran over your dogma.
I'm sorry, but my karma just ran over your dogma.
Re: Missing Patchcords in Scope5 Modular Examples
Does he ever?
Re: Missing Patchcords in Scope5 Modular Examples
arrghh those missing cables are giving me grief
Im still new to Scope and modular.
I was learning by loading presets and looking how they were routed but since the update my cables have vanished
Im still new to Scope and modular.
I was learning by loading presets and looking how they were routed but since the update my cables have vanished
Re: Missing Patchcords in Scope5 Modular Examples
Just latch onto a Module and move it around a little bit, and then snap it back into place.
It remebers everything you have done, the GUI just seems like it needs to catch up.
Also, the GUI occurances vary from user to user.
My cables never disappear but rather still show where they last were. So I can drag a module over the top and they disappear and show their newest placement.
It remebers everything you have done, the GUI just seems like it needs to catch up.
Also, the GUI occurances vary from user to user.
My cables never disappear but rather still show where they last were. So I can drag a module over the top and they disappear and show their newest placement.
Re: Missing Patchcords in Scope5 Modular Examples
I get this fault in scope 4.5 and to get around it I have had to right click the module, disconnect then re-connect. Not much help if you didn't know where the cables were supposed to go though.
Re: Missing Patchcords in Scope5 Modular Examples
I'll try out a few things
Pretty sure i have tried moving modules around but the cables didnt show.. fingers crossed i can make them reappear
Pretty sure i have tried moving modules around but the cables didnt show.. fingers crossed i can make them reappear