Hi,
If there was a PCI card Scope installed on the same PC as Xite - would it be necessary to have 2 installations of the Scope Fusion Platform software?
Xite - PCI-e
Scope - PCI
2 seperate sytems but on same PC
I hope one installation would be needed as this would mean one project only for SFP.......
Xite with PCI card Scope Pulsar 2 etc....
Re: Xite with PCI card Scope Pulsar 2 etc....
i think it needs 2 dedicated installs, one scope pci and one scope xite.
I have not tried it, but i see scope pci and scope xite as different packages on the sonic-core ftp, so it makes sense.
I have not tried it, but i see scope pci and scope xite as different packages on the sonic-core ftp, so it makes sense.
Re: Xite with PCI card Scope Pulsar 2 etc....
It works very fine for me, here, since around 3 years now.
Yes : you need 2 scope installation and run them at the same time. The xite & pci Scope are specific and the xite one cannot be loaded with pci boards (and the opposit as well).
Then you can use (like I do) the pci & xite adat i/o for sounds data between both system. In this way, you still have all your pci i/o.
Yes : you need 2 scope installation and run them at the same time. The xite & pci Scope are specific and the xite one cannot be loaded with pci boards (and the opposit as well).
Then you can use (like I do) the pci & xite adat i/o for sounds data between both system. In this way, you still have all your pci i/o.
Re: Xite with PCI card Scope Pulsar 2 etc....
Scoperise to the rescue:
Dante wrote an article about this a while back:
http://www.hitfoundry.com/issue_12/pcx_mast.htm
Dante wrote an article about this a while back:
http://www.hitfoundry.com/issue_12/pcx_mast.htm