"direct mixer out" set to scope p-plate not remembered

Discuss Scope XTC mode.
Post Reply
User avatar
ARCADIOS
Posts: 1281
Joined: Tue Aug 02, 2005 4:00 pm
Location: GLYFADA ATHENS GREECE
Contact:

"direct mixer out" set to scope p-plate not remembered

Post by ARCADIOS » Thu Dec 23, 2010 1:41 am

in xtc mode the direct mixer output settings are not kept.
is there a setting i must do.
i remember that in the past the xtc ully was also not kept but it was solved after modifying the cset.ini

what about the direct mixer output, which i can select once i open the daw...but after restarting the daw it is blank..and needs to be set again.
????
ELVISLIVES

User avatar
ARCADIOS
Posts: 1281
Joined: Tue Aug 02, 2005 4:00 pm
Location: GLYFADA ATHENS GREECE
Contact:

Re: "direct mixer out" set to scope p-plate not remembered

Post by ARCADIOS » Thu Dec 23, 2010 1:53 am

solved by setting asio out to "direct mixer" in and then "direct mixer" out to scope analog dest.

what is exactly the direct mixer module in xtc?
ELVISLIVES

fraz
Posts: 837
Joined: Fri Jun 03, 2005 4:00 pm
Location: Springfield !

Re: "direct mixer out" set to scope p-plate not remembered

Post by fraz » Fri Jun 22, 2012 2:21 am

Hi I think its the "Direct Play Mixer Container"......

Post Reply