If you want to use SC-Room-5.1 Surround-Reverb in Cubase in XTC-Mode as a send-effect, here is a working environment:
Create a new Bus in VST-Outputs:
IMPORTANT!: Take the 6.0 Cine preset
Load SC-Room-5.1 as an insert to that bus. Best turn the DRY-knob to cero, cause we want to use it as a send-effect.
Deactivate the Lfe.
Now you can route a send in your channels to the 6.0 cine out - left channel. The plugin takes the left or/and right channel as input.
That's all.
The order of the channels inside the plugin is: Left - Right - Center - LS - RS - Lfe. The Cine 6.0 is the only preset in Cubase with the same order (except the Centersurround, which you can leave blank in this case).
(For shure you have to do the dll trick before)
SC-Room-5.1 Surround-Reverb in Cubase, TIP!!
Re: SC-Room-5.1 Surround-Reverb in Cubase, TIP!!
It is a two input, six output device and should load fine in XTC mode with hosts who support that kind of thing.