I have all the synth and sampler packages for Scope 4.5, running in Cubase SX3 under XTC mode:
Volkzampler:
When I try to use Volkzampler in Cubase SX3 in XTC mode it seems to believe the synth is installed but will not bring up the surface interface when I hit the edit button – instead it just shows a small tools bar. Also it only creates a single mono channel out put when it should show multiple outputs.
I downloaded the latest version of Volkzampler from the Creamware website. I have 2 entries for the Volkzampler in my allkeys file, but when I tried to install Volkzampler, it told me that the first key was not correct, and when I tried to use the second key the Set up programme crashed.
U KNOW 007:
When I try to use this synth I get the following error:
“Can’t find DSP file U KNOW filter 2 – please check installation”
Is this a know error and will it effect the working of the synth?
Save project at start up:
I definitely do not have this box checked but Scope still loads on start up – what could I be doing wrong?
Synths that do not work in XTC mode:
Apart from the STS samplers are there any other synths that won’t work in XTC mode – I need to make sure all that can work are working.
XTC Install directories:
Why are there 2 entries for installation directories for the XTC plugins during the install procedure and are they both needed in my set up?
Thanks all .....
Synths in Scope 4.5
Thanks for the advice - but how do I reinstall just one synth without going through a complete install of the whole environment - (I have tried that but it still doesn't work) --- any advice on Volksampler? Do I have to instal that from the Setup.exe and has anyone experienced the setup crash I am experiencing?
Cheers,
Crae
Cheers,
Crae