two cards but only one analogic out - help me!

burdello · Post by **burdello** » Fri Nov 12, 2004 6:30 am

First, nice to meet you. this is my first post

I'm andrea from italy, i'm a PulsarII & powersampler owner.
I use only XTC mode in cubase SX 2.2.0.33. my SFP release is 4.0.
well:
when i set my card's outputs i can flag the pulsarII & powersampler outputs but in cubase the pulsar outputs is the only activated: no powersampler outputs!, the dsp works right but no powersampler outputs. even i can't assign the directplay to PS Analog output.
I have try editing XTCprocject.pro inserting manually PS Analog output, connected to a new AISO output:

now i can use two outputs to monitoring recordings but, if i set directplay to PulsarII Analog output and i press the directplay function on a sinth these message error is prompted:

note: in my cset.ini:
[XTC-Config]
DirectPlayOutPad2=RIn
DirectPlayOutPad1=LIn
DirectPlayOut=Pulsar2 Analog Dest
AddHost=2

[Host]
Scoperev=128

[Host-Config]
Numboards=2
Board0=Host

[hw]
numboards=2
intBlkSize=256

Please give me a solution!!!
ciao

<font size=-1>[ This Message was edited by: burdello on 2004-11-13 21:27 ]</font>

<font size=-1>[ This Message was edited by: burdello on 2004-11-25 13:18 ]</font>

burdello · Post by **burdello** » Thu Nov 25, 2004 12:41 pm

when I assign directplay mixer in this XTCproject.pro:

burdello · Post by **burdello** » Thu Nov 25, 2004 12:46 pm

without this XTCproject.pro (using the dafault by creamware) I can check the powersampler but, pressing "reload" I can't find it in "VST inputs" & "VST outputs" from the "device setup" window. (but the pulsarII i/o)

kriminal · Post by **kriminal** » Wed Feb 23, 2005 2:07 pm

caro burdello, anche io ho lo stesso problema da mesi: pulsar 2+powersampler ed in xtc mode non compare l'output della powersampler: provai al tempo anche a chiedere aiuto alla midimusic, dimostratasi nel tempo sempre gentile e preparata, ma mi si rispose che era la prima volta che sentivano di un problema simile...
Nelle mie ricerche ho trovato una comunicazione della creamware di cui ti lascio l'indirizzo.
Una cosa che ho capito a proposito: la pulsar2 deve essere master, e forse in xtc mode non si può scendere al disotto dei 13ms di latenza per incompatibilità con la powersampler (di questo non sarei sicuro).
Fammi sapere se riesci a risolvere il problema, o se hai qualche idea a riguardo.
a presto.
ecco l'indirizzo: http://shop.creamware.de/shop2000/de/sh ... enDocument

AltMR · Post by **AltMR** » Sun Jun 03, 2007 1:34 am

I've got similar problem with directplay - the same error masseges.
I have 2XScope Project (12 DSP).
Anybody solved this ?