Hello All!
Is there a way that allows to name the various ports?
Ex: "Scope [2] ADAT A DEST" could be changed to whatever external device is connected to the port?
Same for other ports, MIDI. AES, SPDIF, Analog, Wave. ASIO etc
It would also be nice to name the various FX processors to DRUMs, VOC Delay 2, String etc..
Any suggestions?
Thanks
Eric
Labels for Hardware resources
Labels for Hardware resources
Anything worth doing is worth doing to the fullest. (quote)
Re: Labels for Hardware resources
Use the following devices:
Destination M
Destination S
External Effect M
External Effect S
External Master Effect
Source M
Source S
Example: For my MPX1 hardware effect processor I used an External Effect S device, setup the right audio ports and saved the device as MPX1.dev. Now I can drop that device in the routing window and connect it to whatever I want.
Destination M
Destination S
External Effect M
External Effect S
External Master Effect
Source M
Source S
Example: For my MPX1 hardware effect processor I used an External Effect S device, setup the right audio ports and saved the device as MPX1.dev. Now I can drop that device in the routing window and connect it to whatever I want.
Re: Labels for Hardware resources
Hi wouterz
Thanks for the advice, this works quite good. The great thing is that the device remembers the patch points too!
Thanks again
Eric
Thanks for the advice, this works quite good. The great thing is that the device remembers the patch points too!
Thanks again
Eric
Anything worth doing is worth doing to the fullest. (quote)