PlanetZ@scopeusers.com

Scope Users Community
It is currently Tue Jun 27, 2017 6:04 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Control Room with 5.1 Setup...
PostPosted: Thu Nov 03, 2011 11:20 pm 
Offline

Joined: Sun Oct 16, 2011 12:11 pm
Posts: 61
Hey guys,

currently I have a 5.1 Tannoy setup in my Control Room but (because of space problems) my primary three screens are located between center and right monitor...

I have a z-link box (8 channels) connected to the dolby setup:
1 - L
2 - C
3 - R
4 - SBL
5 - SBR
6 - Sub
7 - LS
8 - LR

What I currently did was just connecting the main mix stereo out to:

L -> C (2)
R -> R (3)
L -> SBL (4)
R -> SBR (5)
L -> High-Cut -> Sub (6) for a little bit of PUNCH...

but I think it's not a good idea to pull the Subwoofer-Signal out of just one Channel of the stereo-mix...
There's not enough boom, the Tannoys are currently NOTHING below ~80Hz and I don't want them to connect to the subwoofer X-over for some reasons.

Now I used the STM 16S for the mix - but this creates the typical dolby-experience and does not represent the original mix and eats a lot of DSPP...
The sub sounds great (with XOver set to 82Hz)...

If I use just a MicroMixer in Mono-Mode and mix L+R a little bit, the sub sounds strange again...

Any constructive ideas? (i know that's not IDEAL!)

Greetings,

Robin


Attachments:
File comment: heat 'em up!
scope_upgrade.jpg
scope_upgrade.jpg [ 904.3 KiB | Viewed 1198 times ]
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron

Donate to help support this community


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group