dawman wrote:Bud have you tried using DSP assignments on Source and Destination Modules prior to loading the DAWMix 32...?
I always assign these to strict duty.
I run out of connections using the 16 outs of the STM 1632 but DSP Assigned Source and Destination modules to DSP 1 and 2 depending if they're ASIO or not seem to really help out.
Corrupted projects retain high DSP counts on DSP 1 and 2 sometimes requiring a total rebuild of the project.
I've learned many odd work arounds after 6 1/2 years of non stop performing.
Hi, HNY !
No I didn´t try that.
Why ?
Well,- I have a humble project I start with and which is always the same.
It loads when I launch SCOPE 5.1 w/XITE-1, some derivate of
new project.pro
There are following objects in the environment:
XITE MIDI I/O, analog I/O, AES/EBU I/O, ADAT A I/O, ASIO 32 float w/ 4 channels In (main out from Studio One or Reaper and main out from Reason) and there are 2 sequencer MIDI sources and destinations as well as Mic/DI module and phones destination module.
Pre-loaded devices are:
Midi-Monitor and Midi-Merge (4in1), HPM control pack, Shroomz Can Control.
Most objects are not connected because there´s no mixer at that point.
That´s what I need always and don´t know if manual DSP assignment makes sense because when re-loaded, SCOPE re-shuffles anyway, isn´t it ?
But, ONCE LOADED, I decide for a mixer according to my needs, later and when all is connected, save as different project w/ different name.
So, you mean, when I load that project mentioned above, it would be helpfull manually re-assigning SCOPE I/O objects every time once loaded and even most not being connected ?
What, when looking at the objects above, would you put on DSP#1 and what on DSP#2 ?
OTOH, I still wonder why I was able creating large synth projects using STM2448X without manual DSP assignment, then running out of SAT connections late, but when using STM1632X, it was more or less a nitemare.
When I tried the 32 stereo channel DAW mixer, I removed all pre-loaded devices (not I/Os) from project and saved.
Then re-loaded, loaded the mixer and loaded the HPM control pack.
When I did connections between mixer main outputs, HPM control pack inputs and outputs to XITE analog out, I already ran into the SAT connection errors and before I was able to connect any ASIO input channel to the mixer.
Also loading Can Control and doing connections was no-go.
That didn´t happen w/ the 24-channel version and same circumstances.
With the 24 channel DAW mixer, I was able running all the I/O devices, connection basic ASIO I/Os, phones, XITE-1 I/Os, then bring in different synths for testing.
Because most synths are stereo out, come w/ onboard FX already and don´t need much EQ and dynamics, I imagined that mixer might be good for that too, not only DAW tracking/mixing.
But the 32 channel version was no-go unfortunately.
Bud