PlanetZ forums - scopeusers.com

utf

Yes, it works fine
I did midi out from your shell to Mod IV midi in.
Midi in to a drum module and a got a pattern.

When you change values in the mds-8 sequencer does it works ok?

Ah, sorry to busy for that. Just tested trigger pulses.

it works at first load and changes are working.
After saving the modular and loading it again, it works with the actual sequence, but changes aren't working.
I can apply changes only by switching project samplerate master|slave back and forth, or by assigning the modular to a new dsp.

Because it is a mdl* can you check if it works when you don't save again the device?
In my system it works even if i save it again. (but i haven't reload it)

* i mean you can make changes and just save the project without saving the device

Do you think i should upload that mod2 shell empty or is it ok that way?

Thanks

leaving the mdl as is, it works, tried to save the project, closing scope, reopening scope, loading the project and it works fine.

Then i tried to load the pattern sequencer and i get some dsp load/communication error messages.

We could load it inside another modular shell with specific in/out routing to manage the pattern seq modules.

Good job, at least it works on the xite.

Thank you,

yes i'll try to see the pattern sequencer now.

Anyway,
Enjoy...

I upload here a modular shell the old Electra. The sequencers are working and the pattern sequencer.

I assigned it to dsp 6.

Enjoy

very good.

Modular seqs timing and feeling is best.

Great we have them on xite again!

Thanks 4 this.

God i would love this!
Cant believe i missed it.

+1

Me too