Hallo,
If i "Protect" a Device or Module, how can i "Unprotect" it afterwards to accomodate or edit it again ?
I see there is a function to protect my Module, wich i have tried, but i don't find a way to unprotect the Module again.
Any suggestions ?
Thanks in advance, best regards,
Medion.
SDK-Question
Re: SDK-Question
you have posted in the wrong part of this forum. Try the developers section
Last edited by t_tangent on Thu Jun 10, 2010 7:53 am, edited 1 time in total.
Re: SDK-Question
according to my limited experience, you cannot.Medion wrote:Hallo,
If i "Protect" a Device or Module, how can i "Unprotect" it afterwards to accomodate or edit it again ?
I see there is a function to protect my Module, wich i have tried, but i don't find a way to unprotect the Module again.
just save a copy of the work before protecting and exporting the device, or dont' save after protecting it.
Re: SDK-Question
Bosone is correct, you cannot unportect a protected device. I always save my project, then optimize, protect and save the device. But I never save a project that is protected because it cannot be worked with after that.
mark winger
Re: SDK-Question
Thanks for the advice.
Regards,
Medion
Regards,
Medion