PlanetZ forums - scopeusers.com

Hi, I wondering where is the many missing presets or can´t open etc. in my SCOPE 7?
See the Attachement below. Earlier SCOPEv5.1 those files etc. make open by clicking.
The install V7 goes well and nothing failure happend.
-Matti

reinstall Scope. something went wrong....

Your project window menus are really strange !

Yes : reinstall scope and in the Scope folder\Devices you should see effect, midi, mixer, modular, plug-ins, sampler, synth and tool forders. It's like your menus are pointing to a wrong place.

For Scope preset, you can set the folder you want in settings -> directories in order to keep your beloved presets anywhere else than on C:.

2 possibilities, JoPo touches on the easiest to check first, that your settings > directories aren't defined properly. You can check that by screenshotting that panel and posting here.

The second being that your ACTUAL directory structures are a mess, which you could check by posting a few screenshots of the subdirectories under scope here.

those menus indicate that the directories are messed up...

the easiest fix is usually a reinstall over the top of the current install.

Hi, I´m now reinstalled SCOPE V7, but the problem is same. I´m installed all in E:
I sent you tree pictures as attachement ( see below SOPE 5, SCOPE and SCOPE 7).
Must I too delete device etc. all them before reinstall? Seems that the reinstall have not effect this
only it the Software itself?
-Matti

https://forums.scopeusers.com/download/ ... w&id=14326
https://forums.scopeusers.com/download/ ... w&id=14325
https://forums.scopeusers.com/download/ ... w&id=14324

Go to Settings, and check the Paths you have there.

Hi, I found some settings (see attachement SCOPE 8 below), but seems that is correct. Is the another settings?
-Matti

https://forums.scopeusers.com/download/ ... w&id=14327

Two Menus to the right: Directories

why E:?

do you have another Scope directory on that PC on another drive?

Hi, Yes I found another Scope directory in C: and i deleted this and reinstall scope v7to E: and everyting seems working now!
Thanks for the help
Yours Matti

great!

Hello again, I will ask You isit any tecnical, better and news difference between a new Mixer STM 2448 V7 and a "old" Mixer STM 2448 V5.1?
Can I without any conseconsiderations use the old STM 2448 with my old Examples?
-Matti

no need to worry.

Good ! That old Scope installation on C: was certainly bad and messed up the system !