ADAT and stability
Posted: Tue Jun 13, 2017 9:13 am
On my Pulsar I plugged ADAT to an ADA8200, with the ADAT input/output A the vu-meter on the micro mixer which I use for the ADAT input sent regularly peaks (every 4 secondes) , on the ADA8200 led indicated that the connection was sync so I decided to plug instead the ADAT input/output B it seems like it's ok for the first time.
But when I re-open my project cubase in another session the same issue appeared (peaks of the ADAT inputs from the ADA8200 (it's a new one). I had to click on SLAVE and re-click on MASTER and after it was sync ... so this installation seems to be very unstable, do you have tips or tricks to use ADAT 'rock solid' ?
(my cables are immobilized by a piece of carton because in the ADA8200 they didn't stop to move if I moved my rack ... )
But when I re-open my project cubase in another session the same issue appeared (peaks of the ADAT inputs from the ADA8200 (it's a new one). I had to click on SLAVE and re-click on MASTER and after it was sync ... so this installation seems to be very unstable, do you have tips or tricks to use ADAT 'rock solid' ?
(my cables are immobilized by a piece of carton because in the ADA8200 they didn't stop to move if I moved my rack ... )