Board (0) is not a luna card - new install

An area for people to discuss Scope related problems, issues, etc.

Moderators: valis, garyb

Post Reply
pastor

Board (0) is not a luna card - new install

Post by pastor »

Having an issue regarding a new install on win 10.
I managed to run the installer with no issues after enabling test mode. The drivers show up fine, the Luna was recognized as "Scope PCI X" or something similar.

However, when i try to launch the Scope app as admin, i get the following error
scope1.jpg
scope1.jpg (9.69 KiB) Viewed 1606 times
pressing OK brings up the following:
scope2.JPG
scope2.JPG (15.13 KiB) Viewed 1606 times
If i try to run it again afterwards, it says:
scope3.JPG
scope3.JPG (16.34 KiB) Viewed 1606 times
I haven't been asked for serials/allkeys yet. I have tried to reinstall, no luck.
Anyone have any experience with this?
pastor

Re: Board (0) is not a luna card - new install

Post by pastor »

And no IRQ conflicts.
scope4.JPG
scope4.JPG (48.07 KiB) Viewed 1604 times
pastor

Re: Board (0) is not a luna card - new install

Post by pastor »

Never mind, re-seating the card and some minor cleaning solved it. Ill let the post stay for reference :)
User avatar
ronnie
Posts: 788
Joined: Thu Jul 17, 2003 4:00 pm
Location: Varies Between 30Hz & 20KHz
Contact:

Re: Board (0) is not a luna card - new install

Post by ronnie »

LOL. The cards need a little TLC once in a while. :)
"I’ve come to the conclusion that synths are like potatoes, they’re no good raw—you’ve got to cook ‘em, and I cooked these sounds for months before I got them to the point where they sounded musical to me." Lyle Mays
Post Reply