parameter change is cracking sound !

[Spielraum]

parameter change is cracking sound !

mixing source:
24bit/44.1kHz

after mastering:
16bit/44.1kHz
why the sound is cracking when change in dynamic parameters in Scope?
can anyone help?
"Störspannungsabstand / Signal to Noise Ratio" or smoother parameter steps...

example:
from a virtue of necessity...
cool freaky, but not always an advantage
...the "click"-sound is the result of audiocracking when change in dynamic parameters
here you can hear the modular4 "SpaceF 4 Slots" vector controlled by an cwmLFO:

> track 10 "Galaktische Hintergrundstrahlung"

ich wünsche planetZ einen wundersam entspannten 2. advent!

[astroman]

hard to tell if the original source is unknown...
reminds at the noise of a radiation indicator
sounds intended ... as it matches the title of the track (which would be 'cosmic background radiation')

cheers, Tom

[garyb]

all devices do this?

[Spielraum]

i know many of the sound generators, sometimes more, sometimes less
parameter controller and envelope attack / release crackle front and rear
even with outboard tone generators...

i think it is the mastering magic
it makes things hear that still went through in the mix
i have a lot of experimenting
cleanest control code (without crackling) programmed in the Korg Legacy!!
i love the MDE-X > no crackle, when play with parameter
the source code is extremely successful!


...just, wanted to re-examine the project, but error message
"XITE reset reload dsp... blabla"
- yes -> XITE crash
- no -> XITE frozen
man man, was nun schon wieder

However, that is not the reason for crackling.
??? now...hours later, i found a connection to the good old problematic workflow in the DSP-folder

see also: http://forums.scopeusers.com/viewtopic.php?f=1&t=33936
JOHN BOWEN Special_Collection-DSP_missing - DeBug 2015_09_28

i check again, found nothing, except uppercase and lowercase characters of dsp-files...
a side effect by thousands of installations??
...boa, ok, again reluctantly accepted challenge
i rollback the original install dsp-folder > copied the current state > absolute same file except uppercase/lowercase, copy "NO"
and yep, just no more error messages when load zarg or spaceF tools
until the next mystery...