Xite 1D /ferrofish A16 adat weirdness
Posted: Sat Sep 26, 2015 9:48 am
I recently got a Xite 1D and Ferrofish A16 ae,
I connect them together via ADAT port 1
Xite as master and Ferrofish as slave @44.1k (the xite will not set itself to slave, I just get a spinning cursor)
but I get a loud constant crackling as soon as I connect.
however if I change the sample rate to 32k, the crackling goes completely
if I set it to 48k it gets worse and at 96k the original signal is drowned out by crackles.
I've cleaned the ports with compressed air, and tried 3 lots of brand new cables.
but nothing works
any idea's
Scope 5.1 Win 7 x64
Xite 1D
I connect them together via ADAT port 1
Xite as master and Ferrofish as slave @44.1k (the xite will not set itself to slave, I just get a spinning cursor)
but I get a loud constant crackling as soon as I connect.
however if I change the sample rate to 32k, the crackling goes completely
if I set it to 48k it gets worse and at 96k the original signal is drowned out by crackles.
I've cleaned the ports with compressed air, and tried 3 lots of brand new cables.
but nothing works
any idea's
Scope 5.1 Win 7 x64
Xite 1D