I would assume you could do this in XTC mode, but can you do it (& if so how) in SFP mode?
(Ok I should probably read the manual, but I'm not at my scope pc right now & I've just thought of this)
native fx on scope synths?
-
- Posts: 1963
- Joined: Tue Aug 19, 2003 4:00 pm
- Location: Bath, England
Just route your sends via ASIO to your host sequencer (e.g. Cubase), apply your fx and then route back into Scope (again, via ASIO) and mix.
You can use a 'dedicated' fx channel or a normal ASIO channel, I don't think that it matters much. You'd have the fx on 100% wet and then just mix the effected signal back into your mix
You can use a 'dedicated' fx channel or a normal ASIO channel, I don't think that it matters much. You'd have the fx on 100% wet and then just mix the effected signal back into your mix